Free sample for Metal Forms Factory from Detroit
Steel products can also be divided by their shapes. We can produce in the following shapes: Forged bars Length up to 16,000 mm Round from 80 to 1,200 mm Ø Square from 140 mm to 460 mm Flat from 30 x 25 mm to 2.000 x 600 mm(in case of a smaller width correspondingly thicker) Shafts Barrel/flange diameter up to 1.600 mm Ø Length up to 15.000 mm Weight from 10 kg to 35.000 kg Discs, pu...
"Quality first, Honesty as base, Sincere service and mutual profit" is our idea, in order to develop continuously and pursue the excellence for Free sample for Metal Forms Factory from Detroit, items won certifications with the regional and international primary authorities. For far more detailed information, please contact us!
Steel products can also be divided by their shapes. We can produce in the following shapes:
|Length||up to 16,000 mm|
|Round||from 80 to 1,200 mm Ø|
|Square||from 140 mm to 460 mm|
|Flat||from 30 x 25 mm to 2.000 x 600 mm
(in case of a smaller width correspondingly thicker)
|Barrel/flange diameter||up to 1.600 mm Ø|
|Length||up to 15.000 mm|
|Weight||from 10 kg to 35.000 kg|
Discs, punched discs, hubs
|Diameter||up to 1.200 mm
(smaller dias correspondingly thicker)
|Thickness||up to 600 mm|
Blocks, plates (forged three-dimensionally)
|Length||max. 6.000 mm|
|Width||max. 1.800 mm|
|Thickness||max. 1.000 mm
(in case of smaller thickness greater length and width)
|Weight||max. 30.000 kg|
Forged tubes, cylinders and other hollow forgings
|Inner diameter||160 mm to 600 mm|
|Length||up to 1,200 mm|
|Weight||up to 10.000 kg|
|Outer diameter||up to 2.400 mm|
|Height||up to 2.200 mm|
|Weight||up to 25.000 kg|
Seamless rolled rings
|Outer diameter||up to 3.500 mm|
|Height||up to 800 mm|
|Weight||10 kg to 8.000 kg|
We can also produce according to clients' designs. If you have your own design, just feel free to contact us.
Oil quenching a bellpeen hammer head machined from 4140/4142 tool steel.
Triplex plastic cap punching die set used with an Airmite air press. Punches are modified 15mm gage pins and the dies are modified 19/32 drill bushing allowing for a .003″ total clearance. Punch and die holders are hardened 4150 steel. Bolsters and stripper plate are ground tool steel. Guide rails are 5/8″ drill rod and rail guides are Drill bushings. The cap nests are aluminum. The dies allow for about .05″ sharpening and are supported buy riser bushings which can be replace with tall ones for additional die sharpening. The plastic slug waste falls though the slots in the front of the lower bolster. Air pressure is 100 PSI.